|
|
|
#1
05-25-2013, 07:47 PM
|
|||
|
|||
Maurice Arnott Intro
Hi There from Cambridge New Zealand. Ive always been keen to do metal shaping I think I took the wrong path in my career as I can spend hours in the shed tig welding rebuilding car panels etc.
I have the parts to build and English wheel and would like to make a decent bead roller as well. Im limited to a couple of welders and basic power and hand tools but its amazing what you can fabricate with just think your way around it. Im self taught on everything I have done, and make plenty of mistakes.  We kiwis are renown for enginuity. I hope to gain some knowledge on this forum. I want to build a volks rod for my boys oneday.
__________________
Maurice Everyday above ground is a good day. 
|
|
#2
05-26-2013, 06:19 AM
|
|||
|
|||
Hello Mozza, welcome to the site, There are some crafty 'yanks' on this side of the pond as well. Visit and contribute often, Everyone knows something that others don't.
__________________
Will
|
|
#3
05-26-2013, 06:49 AM
|
||||
|
||||
|
Welcome Mozza.
I lived in Cambridge when I was a we slip of a lad. Williams St next to the football ovals. Jim
__________________
Nothing is to hard its just how much time you want to give it. Last edited by ozi jim; 05-26-2013 at 06:52 AM.
|
|
#4
05-26-2013, 07:30 AM
|
|||
|
|||
|
HI Maurice welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
