|
|
|
#1
11-08-2013, 01:37 PM
|
|||
|
|||
Glad To Be Here
Nick in upstate New York here. Have an MG and an Austin Healey that I have made some simple patch panels for, then found this great site. Took a course in Michigan on welding and patch panel making that sparked my interest. Never thought of making a whole car (well maybe someday).
Glad to be here. ______________________________ NJM
__________________
Nick 
|
|
#2
11-08-2013, 03:35 PM
|
|||
|
|||
Hello Nick and welcome to allmetalshaping.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#3
11-08-2013, 04:45 PM
|
||||
|
||||
|
Hello Nick and welcome.
Did you gas or MIG weld your patch panels in? Did you butt weld or overlap? Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#4
11-08-2013, 06:48 PM
|
|||
|
|||
|
Hi Nick welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
