|
|
|
#1
04-26-2014, 03:10 AM
|
|||
|
|||
Hello from New Zealand
Hi I am Zollis. This site was referred to me by Ozi Jim. Thank you Jim, here I am. I am from NZ North Island were steel rusts very easily. I prefer to work in aluminium or aluminum as it is also known.
I prefer to look at photos, rather than read long descriptions and would like to learn the finer tricks of how to manipulate the "sheet". Z.C.
__________________
Zollis. Doing the best we can do. 
|
|
#4
04-26-2014, 02:16 PM
|
|||
|
|||
|
Hi Zollis welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
04-27-2014, 05:26 AM
|
|||
|
|||
|
Welcome to the forum Zollis.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#7
04-28-2014, 01:30 AM
|
|||
|
|||
|
First I would like to thank the Admins for accepting me to this site, thank you for the warm welcome by everybody.
I will start off searching the archives before I ask any questions that's been covered before. Z.C.
__________________
Zollis. Doing the best we can do.
|
|
#9
04-29-2014, 09:21 AM
|
||||
|
||||
|
Welcome to the site Zollis.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
