|
|
|
#1
03-07-2015, 04:13 PM
|
|||
|
|||
gearhead from Maryland
My name is Steve Robinson, from Mt Airy Maryland. While doing some research on making body panels from scratch I stumbled upon this forum and found there was a lot of great information here and some very helpful people. While I have some body and paint work experience, the only panels I have made from scratch are some hood scoops, rocker panels and lower fender panels. I don't have much experience with making pieces with compound curves. I have a 97 Dodge Quigley 4x4 conversion van that gonna need a lot of rust repair done to it, and I also have an old 41 knucklehead trike that I would like to build a body and fenders for. I am all the time modifying gas tanks, oil tanks, and widening fenders so I think I could learn some valuable skills here. I hope to be able to contribute something useful in the future.
__________________
Steve Robinson 
|
|
#2
03-07-2015, 07:42 PM
|
|||
|
|||
|
Hi Steve welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
03-08-2015, 11:04 AM
|
|||
|
|||
|
Welcome to the site I am in Frederick
__________________
Bryan
|
 |
|
|
Linear Mode
