|
|
|
#1
08-01-2015, 12:45 PM
|
|||
|
|||
New member
Hello all, my name is Ron and I'm from Southern Delaware. I tinker a bit with antique motorbikes and have come to a point where I'd like to move from the usual stuff and into fabrication of frames and sheet metal. I can't think of a better place to start than here. Many Thanks, Ron
|
|
#2
08-01-2015, 06:23 PM
|
|||
|
|||
|
Hi Ron welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
08-04-2015, 04:49 PM
|
||||
|
||||
|
Hello Ron and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
