|
|
|
#1
01-19-2016, 08:12 PM
|
|||
|
|||
Hi all
Hi all, I'm Ray obviously new to this site. I'm 49 years old and have loved old cars all my life, and figured it was time to start fixing/building one:):).
I don't have any trade skills but I've been a tradesman assistant for a couple of good boilermakers and fitters. I found this site though a link on Peter Tommasini's web site. So figured it would be a good place to learn a bit about shaping metal.. Thanks for having me Cheers Ray.
__________________
Ray 
|
|
#2
01-20-2016, 05:09 AM
|
|||
|
|||
|
Hi Ray welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
01-20-2016, 12:44 PM
|
||||
|
||||
|
Hello Ray and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
