|
|
|
#1
02-02-2016, 04:30 PM
|
|||
|
|||
Hello from Belgium
Hello to everybody,
I am from Belgium and owner of several oldtimer. I admire the work of people making from a metal'sheet a nice and curving piece. I must also say that i have 2 left hand..but would like to manage restoring one of my car : a rare Ghia 1500 gt in a very poor state. I will read your post and try to copy what i will learn. Best regards Philippe 
|
|
#2
02-03-2016, 12:52 PM
|
||||
|
||||
|
Hello Philippe and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
02-03-2016, 05:02 PM
|
|||
|
|||
|
Hi Philippe welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
