|
|
|
#1
03-04-2016, 04:09 PM
|
|||
|
|||
low rider
I'm making a bike out of metal tubes including part of a trampoline . I am shaping, welding, rubbing and have just sprayed primer on my latest project. I am a qualified cycle mechanic and enjoy fabrication. I had a V8 trike and made most things in my shed.
|
|
#2
03-04-2016, 06:44 PM
|
|||
|
|||
|
Hi Keith welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
03-05-2016, 07:39 AM
|
|||
|
|||
|
I hope the tubing is no galvanized . bad stuff to breath when welding , it will give you the zinc shakes not kidding
|
|
#4
03-07-2016, 11:54 AM
|
||||
|
||||
|
Hello Keith and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
