|
|
|
#1
03-17-2016, 06:44 PM
|
|||
|
|||
Hello I am new here from The Netherlands.
Hello. My name is Jack Arts.
I live in The Netherlands After school, I started as a fabricator/welder in a race shop. We prepared race cars and bodyshells for race, rally, rallycross and Dakar. We fabricated all the parts that we could weld.After 20 years the time has come for a new job. Now I am working in a body shop for aluminum body restauration. I have still a lot to learn. From gaswelding aluminum to work with the Eckold. Last 10 years I spent a lot of my time on my Datsun 260z. After some simple floorpanels changed my plans. I made wide fender flares with an english wheel and I did a top chop. I had to learn a lot. And now in the bodyshop, can I do this for the living. I like to use this forum to meet and learn from other enthousiasts. Jack Arts
__________________
Greetz Jack Arts Datsun 260z s30 top chop 
|
|
#2
03-18-2016, 03:01 AM
|
|||
|
|||
|
Hi Jack welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
03-18-2016, 12:19 PM
|
||||
|
||||
|
Hello Jack and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#4
03-19-2016, 01:19 AM
|
||||
|
||||
|
Hi Jack,
Welkom. I live in Brabant too. Eindhoven region. Where are you from? Gaswelding ali is a bit different but there are different ways to do it. A lot of info on these fora. Frank
__________________
Frank de Kleuver
|
 |
|
|
Linear Mode
