|
|
|
#1
05-14-2016, 10:01 PM
|
|||
|
|||
From Santos SP Brazil
Hello my name is Joseph Palladino and along with my brother Renato , we work with the restoration and reconstruction of old cars bodies and structures in Brazil. We have in our workshop one Franho C6 that like a Pullmax P6 and would like to learn about the limitations of this equipment relative to the maximum working depth . Such as what is the most prfundo and wide design that I can do on a 03/64 inch steel plate SAE 1008. Is there any tutorial or someone can tell me . I am very grateful and I hope in the future can also contribute experiences. Thank you
|
|
#2
05-15-2016, 08:16 AM
|
|||
|
|||
|
Hi Joshep welcome to the forum
I am not too familiar with '' Franho C6''..... but I am sure someone on the forum will help you w  Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM Last edited by Peter Tommasini; 05-15-2016 at 08:18 AM.
|
|
#3
05-15-2016, 04:45 PM
|
||||
|
||||
|
Hello Joseph and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
