|
|
|
#1
10-11-2016, 02:53 PM
|
|||
|
|||
Newbie: bead rolling
Diesel mech looking for a side hobbie
Other than metal shop back in high school have I done any metal fabrication so my knowledge is limited. I would like to learn sheet metal fab to build a firewall floor pans and trunk pans for a few projects I have, possibly a few suspension systems, possibly cages and 4 link type suspensions. Tooling is available and I am the type to invest in tooling due to my trade, not afraid to spend for quality Tools I currently possess are Miller syncrowave 210, normal hand tools, and a BFH. In the process the purchase of a Woodward bead roller to practice and get my feet wet in bead rolling. I always welcome trade off of info so I'll gladly answer any engine questions out there
__________________
-Jordan 
|
|
#2
10-11-2016, 06:33 PM
|
|||
|
|||
|
welcome to the forum.
There is a lot of well versed people here when it comes to bead rolling. I also like to watch youtube vids on any of those metal shaping subject.
__________________
Marcus Goetting If it was easy -- they would do it at Walmart  www.mgcustomairframe.com www.facebook.com/mgcustomairframe/
|
|
#3
10-11-2016, 07:09 PM
|
||||
|
||||
|
Welcome
Welcome aboard! You have landed in wonder land and there is so much information and skills present. You'll have no trouble finding the answers and information you want but not from me, I'm a newer nebee!
__________________
Bob
|
 |
|
|
Linear Mode
