|
|
|
#1
02-01-2017, 06:03 PM
|
|||
|
|||
Leo from Colorado
Hi all,
I am Leo from Colorado and I am currently working on patching up a 1973 VW Bus that I just completed a Subaru conversion on. I have completed a few engine conversions in the last ten years; the first conversion was a KDX175 motor into a homemade off road go-kart, a 4BT Cummins into a 1977 Ford F150 short bed, and most recently an EJ25 into a 1973 VW Bus. I like learning new skills and have always wanted to work with metal. In the past 6 months I finally purchased a MIG welder and also purchased a cheap bead roller and metal brake. I have three vehicles that need a bit of metal work done on so I am hoping I can learn from others on this forum. I am also very excited to see what others are making with their hands!
__________________
Leo 
|
|
#2
02-01-2017, 08:22 PM
|
|||
|
|||
|
Welcome to the forum.
__________________
Ezekiel
|
|
#4
02-02-2017, 01:15 AM
|
|||
|
|||
|
Hi Leo welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
