|
|
|
#1
03-11-2019, 02:20 PM
|
|||
|
|||
New Member from MI and FL, USA
My name is Eric and I joined as I have been reading posts on this site for over a year now. I have no experience with metal shaping, but have been reading and watching DVD's by many members here including: Peter Tommasini, Peter Gardiner, and Kent(tinman).
I have a few small projects that I hope to get started on soon, including some small rust holes and trim holes that need to be welded up on my car. I have many future projects, (mostly old trucks) but unfortunately I will need to spend most of my time moving from FL back to MI and that will take some time. Once back, getting a shop setup will take more time, but I'll get there. I used to do photography and would like to start up with that again, and I also have a desire to learn Blacksmithing. Thanks for this forum... I'm not a full member yet, but it is amazing and I am looking forward to getting started.
__________________
Eric 
|
|
#2
03-11-2019, 04:55 PM
|
|||
|
|||
|
Welcome to the forum, Eric
|
|
#3
03-11-2019, 05:14 PM
|
|||
|
|||
|
Welcome to the forum, Eric.
__________________
AC Button II http://CarolinaSculptureStudio.com https://www.youtube.com/channel/UCzSYaYdis55gE-vqifzjA6A Carolina Sculpture Studio Channel
|
|
#4
03-12-2019, 01:35 AM
|
|||
|
|||
|
Hi Eric Welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
03-12-2019, 02:04 AM
|
|||
|
|||
|
Welcome here!
Good luck with the moving and setting the new shop! Antoine
__________________
Antoine Puygranier Resurrecting a 60 ghia: http://www.allmetalshaping.com/showthread.php?t=18852 Fixing a 914: https://allmetalshaping.com/showthread.php?t=20624
|
|
#6
08-26-2019, 02:18 PM
|
|||
|
|||
|
Thanks everyone,
I have not done much but continue to watch DVDs, but if plans work as I hope, I will be taking a Dagger tools class while I am in MI this fall. The principles sink in a little more every time I watch them. I have watched them so many times now that I feel like I can start making panels immediately, I know this is not the case, lol. In between, I have plans to get a small shop set up so I can start practicing. Eric
__________________
Eric
|
 |
|
|
Linear Mode
