|
|
|
#1
11-21-2010, 07:43 PM
|
|||
|
|||
Another lurker comes clean
Greetings all, Ive been here almost from the begining, hiding in the shadows. Im a diesel tech during the day and a performance engine builder/dyno operator at night and weekends. My yard is full of potential projects and a racecar or two that have been sitting due to our economic downturn. I do have a shop with tools and a supportive wife. In these modern times I take for granted a site like this and what it takes to make it work,not to mention the calibur of talent here. So from a longtime lurker thanks for the education and information overload. Im also a better reader than i am a typer. AL V.
|
|
#2
11-21-2010, 07:53 PM
|
||||
|
||||
|
Al, welcome to the site and thanks for the introduction. You have the most important thing to be in your kind of business, a supportive wife. Hope to see you post some of your work.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
11-22-2010, 01:37 AM
|
|||
|
|||
|
Welcome to the site Al.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#5
11-22-2010, 09:11 AM
|
|||
|
|||
|
Welcome Al,
I'm in North Fort Myers, it's nice to have some local folks here. There's a lot of knowledge here ready to help with just about any question you have.
__________________
.................Bill
|
|
#7
11-23-2010, 09:58 AM
|
|||
|
|||
|
You're probably 20-25 minutes from my house. My shop is 5.4 miles north of the river on US-41 so it's a bit farther away. You're welcome to visit the shop if you're in the neighborhood. I have a few toys you might enjoy.
And not that I'm any sort of expert but if you need anything, just let me know and I'll try to help.
__________________
.................Bill
|
 |
|
|
Linear Mode
