|
|
|
#1
01-27-2011, 02:14 PM
|
|||
|
|||
My intro
My name is Will, I design and build choppers from the ground up... I specialize in frames and sheet metal fabrication. Im a tool junkie. My shop is located in my Garage in Louisville Ky right now and includes:
Bench Top English Wheel built to Kent Whites plans with Hoosier Wheels Bench Top Power Hammer built to Kent whites Plans Gitzit Planishing Hammer (I LOVE THIS) Pullmax T-3 (we are just finishing cleaning this up - bodyworked and repainted) Erco Kick Shrinker Lancaster shrinker and Stretcher Stimpled By Neil Dunder (he does magic to these machines!!!!!!!!!!!!) Bridgeport Mill 42"x9" Clausing Colchester Lathe 10k Southbend Lathe Dake Cold Saw Burr King 760 Belt Sander (most used tool in shop) Fully adjustable CNC machined Frame Jig Jd2 32 Tube Bender Miller syncrowave 200 Oxy Acytelene rig with Meco torch and Henrob torch Miller Millermatic 200 Lots of hammers (I'm allways looking for good vintage Plumb - I love them) Dollies Shrinking Discks Etc etc Don't know what else to say... I love this site! Love this site Thanks Will 
|
|
#2
01-27-2011, 02:40 PM
|
||||
|
||||
|
Will, welcome to AllMetalShaping and thanks for the introduction. When you get a couple more tools you will be able to start doing something..
 . Many of us here have the same disease and there is no cure. Thanks for joining us. Glad you enjoy the site.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
 |
|
|
Linear Mode
