|
|
|
#1
11-05-2011, 10:53 PM
|
|||
|
|||
Hello to all
I'm glad I found this site. I'm a rookie that is here to learn the basics of metal shaping. Thanks in advance for sharing your knowledge.
__________________
Reggie 
|
|
#2
11-05-2011, 11:31 PM
|
||||
|
||||
|
Reggie, Welcome and thanks for the introduction. There is a lot of information here to help you get started and learn sheet metal shaping. Ask questions if you have them. Hope to see some of you work as you progress. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
11-06-2011, 04:34 PM
|
|||
|
|||
|
Hi Reggie, welcome to the site, I am sure you will find lots of interest to you here.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
