|
|
|
#1
02-01-2012, 01:17 PM
|
|||
|
|||
Sheet Metal Virgin
Well, I'm not a total virgin to working with sheet metal, but almost all of my experience has been with tubing, angle, plate, etc. I have done some very simple things with sheet metal, but I am looking to move beyond the "rolling over" stage to the "crawling stage".
 From what I've read so far, there is a lot of information here which should really help me out. I need to read a lot before I can ask any questions, but this sure looks like the place to be.Marty
__________________
Marty 
|
|
#3
02-01-2012, 04:09 PM
|
||||
|
||||
|
Marty, welcome and thanks for the introduction. Lots of information on the site the help you improve you skill and learn new methods. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
02-01-2012, 04:24 PM
|
|||
|
|||
|
Welcome to the site Marty
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
02-01-2012, 06:10 PM
|
|||
|
|||
|
Hello Marty, welcome to allmetalshaping.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
