|
|
|
#1
06-09-2012, 01:49 AM
|
|||
|
|||
Hey everybody Chris here with an Intro
Hi ALL,
My name is chris and found this fourum as i was searching for some e-wheel anvils (as currently i haven't access to a lathe) and read a few threads that were packed with alot of good info, anyways here i am! A little about myself i have always been of the fabricating type mainly because growing up if i wanted something i couldn't afford i figured out how to build it. That led me into the Automotive industry starting out in a dealership and and working up to the world of motorsports (rally racing) where it was there that i shifted some attention back to sheet metal crafting instead of the more structural work like building roll cages, sub-frames, body modifications and chassis work that i was immersed in. I had taken a metallurgy course offered by fay butler and it was at that course the proverbial light switched was flipped and i had to learn and attempt to improve more in the relm of metal shaping. Currently i'm in the beginning stages of building an E-wheel and have been looking over the different design and construction options. I look foward to indulging into the vast amount of knowledge in this forum and it's participants, while helping anywhere i can. regards Chris...you can now wake up : )
__________________
"the man who was too old to learn was probably always too old to learn" Chris 
|
|
#2
06-09-2012, 08:34 AM
|
||||
|
||||
|
Chris, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
06-11-2012, 07:21 AM
|
|||
|
|||
|
Welcome to All Metal Shaping Chris!
__________________
Nick M. Some more projects: http://www.facebook.com/iNVisionPrototypes https://www.instagram.com/invisionprototypes https://www.youtube.com/c/iNVisionPrototypes
|
|
#5
06-11-2012, 08:25 AM
|
||||
|
||||
|
Welcome Chris
|
 |
|
|
Linear Mode
