|
|
|
#1
06-24-2012, 11:23 PM
|
|||
|
|||
New Canadian
Hi all, my name is Greg and I found this site through a coversation with Dan Pate (Hope that is your correct name) at Back to the 50's this weekend. I used to be a regular on the metal meet site, but in the last few years I have not been doing much metal shaping. I used to do a lot of restoration/custom work at my shop but in the past few years we have been mainly doing collision repairs as that seems to pay better these days. I am about to start on a project of my own again ( a 1950 Chev pickup) and hope to put some of my shaping tools to use soon. I am a much better fabricator than a metal shaper and look forward to learning from you all. After looking through the site, I see many familiar names from the other site.
__________________
Greg 
|
|
#2
06-24-2012, 11:30 PM
|
||||
|
||||
|
Greg, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
06-25-2012, 07:19 AM
|
||||
|
||||
|
Hi Greg, Good to hear from you again. Welcome to AllMetalShaping.
__________________
Kerry Pinkerton
|
|
#6
06-25-2012, 11:33 AM
|
||||
|
||||
|
Not yet Greg. Here is the build thread. http://allmetalshaping.com/showthrea...highlight=deco
__________________
Kerry Pinkerton
|
|
#7
06-25-2012, 10:02 PM
|
|||
|
|||
|
Hi Greg! Welcome to the forum from Niagara Falls, Ontario
 You'll find a great gang here.Cheers!
__________________
Nick M. Some more projects: http://www.facebook.com/iNVisionPrototypes https://www.instagram.com/invisionprototypes https://www.youtube.com/c/iNVisionPrototypes
|
|
#8
06-26-2012, 12:56 AM
|
|||
|
|||
|
Hello Gregand welcome to allmetalshaping!.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
