|
|
|
#1
07-13-2012, 01:34 AM
|
|||
|
|||
Gday from WA
Thats Perth WA Australia.
 The names Brian and my hobby is motor cycles. To be more specific it is constructing sidecars for my bikes. I built one last year that was very sucessful and with a new bike I am again embarking on the fabrication. Last years model was relativly easy with a tubular chassis and a six sided aluminium body attached. This time around i want a body with flowing lines to accentuate the lines of the motor cycle. It is a Yamaha Roadliner. What i hope to gain from this forum is the knowledge to attempt to shape the aluminium to the style i require. Thanks for your interest> Cheers Brian 
|
|
#2
07-13-2012, 01:42 AM
|
||||
|
||||
|
Brian, welcome and thanks for the introduction. Hope you find the site helpful and enjoyable. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
07-13-2012, 06:18 AM
|
|||
|
|||
|
HI Brian and welcome to AllMetalshaping
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
07-13-2012, 06:47 PM
|
|||
|
|||
|
welcome to allmetalshaping brian
__________________
Clive ross
|
 |
|
|
Linear Mode
