|
|
|
#1
07-21-2012, 11:03 PM
|
|||
|
|||
Howdy from Colorado
Been lurking for awhile and finally registered to take advantage of the info here. I had a small louver punching business in the 80's and always wanted to get into more shaping. The time is right for me to get into beatin' tin.
Doug 
|
|
#2
07-22-2012, 03:47 AM
|
|||
|
|||
|
HI Doug welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
07-22-2012, 07:38 AM
|
||||
|
||||
|
Hi Doug.
Welcome to the site, probably the best place for technical info from guys that do shaping as a way of live.
__________________
Tom Poulter Follow the Dream - Sideways -  - But don't fall-off the edge'good to know you guys care' https://ctrestorations.com/
|
|
#4
07-22-2012, 08:51 AM
|
||||
|
||||
|
Doug, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#7
07-22-2012, 02:40 PM
|
||||
|
||||
|
Welcome
Down in RockyFord, Welcome !!!
I'm just sick of 30 years of BONDO and am hoping to glean a little off these craftsmen here. 
__________________
Gerry Miller
|
|
#8
07-23-2012, 07:16 AM
|
|||
|
|||
|
Hi Doug and welcome to allmetalshaping!
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
