|
|
|
#1
02-09-2013, 10:28 AM
|
||||
|
||||
Hello from new member
I joined this forum to learn more about the craft of sheetmetal forming.
I've already done a lot of metal fabrication with tubing, plate, etc, using welding, machining, etc. As a teenager, I did a little bit of sheetmetal work on a vehicle, and the results were so-so. Now that I'm older and wiser, I know much more learning and practicing is needed before I just dive into this craft. I've already purchased some hammers, and just made a tuck puck for shinking, and a shot bag. Once I learn more, I'll look at an english wheel and planishing hammer setup. This looks to be a good forum with some knowledgable people that also seem to be more well mannered than some of the forums I've seen. Thanks Kent
__________________
Kent Eastern South Dakota (work & home) Researching sheetmetal shaping and forming, starting to buy the tools and practice the techniques My shop projects: www.kustomsbykent.com 
|
|
#2
02-09-2013, 12:16 PM
|
|||
|
|||
|
welcome
Hello Mr. Kent,
Welcome to the site, there is much to learn here and alot of friendly people willing to help out. Any cool metal related things to be seen in china?
__________________
Cody
|
|
#3
02-09-2013, 06:19 PM
|
|||
|
|||
|
HI Kent welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
