|
|
|
#1
05-16-2013, 09:41 PM
|
|||
|
|||
New here! On the coast
Just joins this fourm hoping to gain some knolage about shaping metal. I live in Gauiter MS. I'm 21 years old. I'm a commerical diver. And I run my own motoercycle repair shop on the side. I saved up some money and loaded shop with some metal shaping equipment. English wheel,planishing hammer. Shrinker strecher. The plan is to start making my own motorcycle parts. tanks fenders, all that good stuff
|
|
#2
05-16-2013, 10:37 PM
|
||||
|
||||
|
Branden, welcome to the site. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
05-17-2013, 05:37 AM
|
|||
|
|||
|
HI Brenden welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
