|
|
|
#1
05-26-2016, 06:32 AM
|
|||
|
|||
Newb Fabrication Guy
Working on cleaning up rust and some panel reshaping on a 76 Mazda RX3. Engineer by trade, after hours I install aftermarket efi ecu's and tune cars. Have always done quite a bit of my own fabrication and thought I would join the group for pointers.
Thanks Ryan Fritts
__________________
Ryan Fritts 
|
|
#2
05-26-2016, 09:26 AM
|
|||
|
|||
|
Hi Ryan welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
05-26-2016, 06:04 PM
|
|||
|
|||
|
Hi Ryan and Welcome.
 Those little RX3 are a great car, as well as R100, RX2 and RX4's. Here in OZ they are all worth a goldmine now, as they are getting harder to find. The R100's are even rarer, with some fetching up to 25k for pretty average ones.  Good Luck with yours, as there is a lot to learn from this site. Cheers John
__________________
John EK Holden V8
|
|
#4
05-27-2016, 12:14 PM
|
||||
|
||||
|
Hello Ryan and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer. Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
