|
|
|
|
|
#1
09-10-2010, 10:57 AM
|
|||
|
|||
Shop projects
David, I have two projects I'm working on. The first is an entertainment center designed after the arts and crafts style--only in steel. I am planning to have three beads on each style, a 1 1/2 X 3 X 14ga rect. tube. The plan so far is bead a piece of 18-20ga cold roll sheet, then capture it in a 1 X 1 X 1/8 angle frame, then apply the frame/beaded piece to the styles. Just as KP predicted the sheet stock rolls in two dimensions....looking for effective means to prestrech/postform with my tools on hand. The other project is a demilune table with forge steel legs(1 1/2 in tapering to 1/2 in square). The hard part is draping a piece of 24 oz copper over an MDF top and make look like a smooth table cloth. By the way I never take on really hard projects.
 Is everything clear as mud?Fox 
|
|
#2
09-10-2010, 11:32 AM
|
||||
|
||||
|
Hi Fox,
Good to have you on board, sure your get loads from guys on here, may I suggest you add your web address to your signature then its there very time you post. See your going to Dixieland - lucky begger.
__________________
Tom Poulter Follow the Dream - Sideways -  - But don't fall-off the edge'good to know you guys care' https://ctrestorations.com/
|
|
#3
09-10-2010, 11:48 AM
|
||||
|
||||
|
Welcome
Welcome fox, I'll see you at Kerry's. Also, my birthday is on the 17, I'll be 52[Man thats old] Mark D
|
|
#5
09-10-2010, 04:06 PM
|
||||
|
||||
|
Fox, welcome to the site. Looking forward to meeting you at Kerry's. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
 |
|
|
Hybrid Mode
