|
|
|
|
|
#1
10-12-2011, 12:07 PM
|
||||
|
||||
Bob, welcome and thanks for the introduction. There is a lot of information here to help you learn how to shape sheet metal. If you have questions just ask and someone will help you. Thanks for joining us and thanks to your son for keeping us free.
__________________
Joe Hartson There is more than one way to go to town and they are all correct. 
|
|
#2
10-12-2011, 12:41 PM
|
||||
|
||||
|
Greetings Bob from another new guy in Jersey.
|
|
#3
10-12-2011, 06:27 PM
|
||||
|
||||
|
Welcome aboard
Not sure about that Wheel but it needs to be stiff. If you have the opportunity to look at it and it has a set of wheels, insert the the flat anvil or if he does not have it just use the axle in the lower cradle. Add moderate to high pressure and this happens it will tell you the frame is flimsy. look to see if the wheels go out of alignment.
__________________
Johnny Arial This forum is dedicated to Metal Shaping. Please stay on topic.
|
|
#4
10-12-2011, 06:51 PM
|
|||
|
|||
|
Thank You for your son's service.
__________________
JC
|
|
#5
10-12-2011, 07:01 PM
|
|||
|
|||
|
Welcome to the site and thanks for your son's service.
__________________
Eric Elkin
|
 |
|
|
Hybrid Mode
